Then on the ‘host’ Mac (Studio in this case), Loopback will show the AVB enabled Mac as audio interface, which you have to route to your needs. You need to do that in only one of the Macs and it’ll appear as an ethernet audio interface in both Macs, up to 64 channels of I/O. The video at the bottom explains how to enable a Mac to be an AVB device (only opening AVB configuration and ticking the ‘enable’ box, you can disregard the matrix). Many people online said that a 400€ AVB switch was needed, but that’s not true! (if you want to integrate a Switch in between it MUST be AVB, but you can use any dongle to add extra ethernet ports for other uses). Pretty mind blown right now that this just cost a regular ethernet cable in hardware. Audio coming from the two computers into the same output are summed. Haven’t measured latency but it’s not noticeably increased using live instruments with monitoring as doing with the Mac host of the ES-9 (audio interface). This can be useful for live use such as redundancy backup, split audio and video/light processing (with audio reactivity), two people (with 2 DAW) performances, offload CPU, AV streaming and many other things I can’t think about now but I’m sure you’ll do. I haven’t tried using video stream with NDI out at the same time in TD though, I’ve read it doesn’t play well with Dante. This is interesting as the routing can be completely independent of TD or DAW, so in case any of them fails, the second computer can still receive and send audio to the audio interface (redundancy setups). Sound Siphon by Static Z Software can be used for hassle-free audio routing, including per-application audio capture.AVB (native) + Loopback (TD or any DAW to route channels) allow two Macs to use the same regular USB audio device (or aggregated devices) with just an ethernet cable between them, sending up to 64 I/O channels.Īlso, Loopback (paid, in the picture below) is nice in case you want independent routing between computers. Loopback by Rogue Amoeba can be used for hassle-free audio routing, including per-application audio capture. Change the Desktop Audio device to VB-CABLE.In OBS Studio's Settings window, click on Audio.Click on Output, then click on the Multi-Output Device you created.Make sure the device you selected in step 5 is set as the Master Device at the top of the window Check one device from which you want to hear audio.Uncheck VB-Cable in the list to the right.Click on the + button at the lower-left of the window.After you have installed VB-CABLE, open the Audio MIDI Setup application.Download VB-CABLE for macOS and run the installer OR install it using Homebrew.It must be set up manually does not support per-application audio capture. VB-CABLE by VB-Audio can be used to record macOS desktop audio. There are many options, including free and non-free software. In order to capture desktop audio on older versions of macOS, you will require additional software. Note: you can combine the new macOS Screen Capture Source audio with the other methods below for advanced control over audio.Ĭapture audio on previous versions of macOS Edit the macOS Screen Capture Source's transformation to set the size to zero width by zero height.Place the macOS Screen Capture Source behind all other sources, or.If you only wish to capture audio, not show any picture, you can either: If you use Window Capture, audio from the entire application will be captured regardless of which window you select. To capture from just a single application, you can use either Window Capture or Application Capture. All audio from all applications will be captured regardless of which display you select. To capture all desktop audio, use Display Capture. If the source is hidden, the audio will be removed. The audio will automatically be added to the audio mixer. When using OBS Studio 28+ on macOS 13 "Ventura" or later, you can capture desktop audio or just the audio coming from a single application.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |